How do I design a photovoltaic and solar hot water system?

Provide an architectural drawing and riser diagram for the homeowner showing the planned location for future photovoltaic and solar hot water system components. Space requirements and layout for photovoltaic and solar water heating system components should be taken into account early in the design process.

Should a general contractor install a solar PV system?

A general contractor may face a choice between using an electrical subcontractor or a solar subcontractor to install the PV system. A good solar contractor will have the expertise in solar PV systems plus qualified electricians on staff.

What should be included in a solar PV system diagram?

The diagram should have sufficient detail to clearly identify: Figure 10: 70-Amp Double Pole Breaker. Figure 11: Site/System Diagram. The diagram should include: array breaker for use by the location, size, orientation, conduit size and location and balance of system solar PV system. component locations.

What guidance is there on the performance of PV systems?

The Good Practice Guide provides some guidance on the performance of PV systems in Section 4 of the updated PV Installers Guide. The PV Specialist should model the system using one of the software simulation programmes available, which have a ‘library’ of modules and inverters and can select the sunlight conditions most representative of the site.

Do you need a pull line for a solar PV system?

To facilitate the wiring of the solar PV system at a later date, the builder may also want to include a pull line in the conduit, particularly if the conduit run is lengthy or has multiple bends.

How should a PV system be designed & installed?

From the outset, the designer and installer of a PV system must consider the potential hazards carefully, and systematically devise methods to minimise the risks. This will include both mitigating potential hazards present during and after the installation phase.