A pre-made generator will be the easiest option for beginners, but tutorials can be found to make your own by searching the internet for "making a wind turbine generator." If you decide to buy a DC generator, look for one rated for high voltage and current and low rotation speed (several hundred instead of several.
[pdf] Amorphous silicon (a-Si) is the non- form of used for solar cells and in . Used as for a-Si solar cells, or thin-film silicon solar cells, it is deposited in onto a variety of flexible substrates, such as glass, metal and plastic. Amorphous silicon cells generally feature low efficiency.
[pdf] The DIY solar kettle is made from replacement evacuated tubes for solar water heater such as in the following link Apricus. The cost of a single tube, as a replacement part, was. .
Making the DIY solar kettle is very simple as it just requires the careful removal of the silicone rubber seal at the opening of the tube. Keep this seal as it will be used as part of the kettle. Next, remove the copper heat transfer tube.. .
When it is time to use the water, I like to replace the water immediately to protect the tube from overheating. To do this I empty the solar kettle into. .
The solar kettle needs to be mounted upright and, if possible, tilted back at an angle so that as far as is practical it is at a right angle to the suns.
[pdf] There are eight known planets orbiting our sun, including Earth. Making a model is a fun introduction to this solar system, and a good art project for primary school science classes. This detailed example can take a few hours to make, but most of that involves waiting for paint or clay to dry.
[pdf] 
