To distribute power in my homemade solar generator, I used a 6-circuit fuse panel for the positives, and for the grounds, I used a busbar. Fix both of these to the case floor using a hot glue gun. Once the glue dries, I recommend you add another layer of superglue all around the edges. Do the same for the positive inline fuse. .
To wire the LED light, you need to shorten the cable just enough to reach the switch. Strip the outer insulation on the end, as well as the insulation of the (+) and (-) wires that are inside. Since the switch also has an indicator light, it. .
Take the leads from the 18V socket and connect the charge controller. Now go ahead and connect the charge controller to the fuse box and negative bus bar. Since I used a solar.
[pdf] We like the clean, uncluttered aspect of the BESTÅ line, but we needed unusual access to the cabinet. .
Besides the cost of the BESTÅ cabinet, it cost an extra single cabinet. We already had the glue and the profile was few euros. It took a couple of. .
We love that it doesn’t look like a hack and that we could use all IKEA things. We did add a non-IKEA extra shelf, but that’s because we wanted one.
[pdf] 
